This tower was created for N scale originally, but we have a customer who contributed the picture. He models Z Scale so he just cut the tower in two which gave him two towers instead of one. He used a Xuron maxi shear cutter. Just be sure to cut each “girder” separately, he says. He also has a small red flashing light on top and he secured the tower to the base with thin stainless steel wire.

This Transmission tower is a fine etched brass prototype It comes pre-painted These towers are very common everywhere. Our model is 11 inches tall. One of the pictures is a prototype of the model This prototype shows the supporting guy wires attached at three levels at angles of 120 ° around the tower.