In all your ways acknowledge Him, and He will make your paths straight... Prov. 3:6

PROUDLY MADE IN THE USA
Free domestic shipping on orders over $75 with the exception of certain products requiring extra shipping.
Complete Shipping details
.  
 Stay informed of new product releases and special promotions by signing up for our newsletter.

0
Your Cart
Item(s)
Qty
Price

No items in your cart

N Scale Power Truck
$99.95
(2)
This 9mm N Scale standard guage power unit will power our N Scale locomotive Shay kit and is sure to find its way into many other applications. It comes with an extended driven shaft to allow you to experiment with PTO drive extensions.

Read More
SKU: 0020
Remove from wishlist Add to wishlist
  • This 9mm N Scale standard guage power unit will power our N Scale locomotive Shay kit and is sure to find its way into many other applications. It comes with an extended driven shaft to allow you to experiment with PTO drive extensions. This extended shaft can be cut to length using regular wire cutters. Please click on the instructions tab below to see more information about this power unit. We will need to send these insured to you, so shipping will be $6.50 for domestic shipping and $12-$15 for International orders.

    Suggestions from Tom Knapp

    A 12VDC train power pack puts out 12VDC (in some cases more) when turned fully flat out. The loco will fly off the track before that happens. At normal operating speeds for the Showcase power unit, the power pack will probably be putting out no more than 3VDC at the track. Operating the power unit flat out for an extended period is impractical at best and careless at worst. In short, just because a power pack says it is 12VDC, doesn’t mean you have to run the train at 12VDC. There are two exceptions to this.

    1. Pulse-Width-Modulated throttles
    These throttles put out short bursts or spikes of voltage – reducing the gap between bursts as you increase the throttle to increase speed. Depending on the manufacturer, these can be 12VDC spikes. In the past I have had some Märklin Mini-Club iron-core motors get very hot is run for long periods of time at train shows using PWM throttles. I have not experienced that heating with the coreless motor Kenji uses. Some manufacturers such as Rokuhan and Varipulse have PWM throttles which are “kinder” to low voltage motors – both coreless and can-type.

    2. DCC
    DCC motor decoders are basically PWM throttles. The decoder can be programmed to get a better range of speed vs. throttle setting for these small motors. Bryan Vianco has a very good tutorial on setting the motor voltage CVs on his web site at tutorialstipstricks. In addition to this, voltage can be reduced electronically using voltage reduction devices between the power unit and track.

    • Repeat purchase
      Please see previous review of this item.....it was so good, I purchased a second one. Excellent quality.
      LDMIKE

      -

      Richmond, VA

      Was this review helpful?

    • Very good drive performance
      I bought the power truck for the n-scale shay locomotive and I’m surprised about the drive performance of this little tiny truck, very scale like and smooth. Only the white gears are distracting, but it can be fixed easily with a black permanent marker.
      Photoart

      -

      Germany

      Was this review helpful?

Newsletter Signup 
Sorry, please correct the following errors:
  • Bullet 1
  • Bullet 2
  • Bullet 3
Thank you for subscribing to our newsletter.
;